Chrysler 20 and 30 HP Outboard Motors Service Manual OB 3435, Page 112Get this manual
NOTE An improvised tool suitable for holding brushes in place can be made from putty knife 7Align rib on motor body with notch commutator end cap and remove putty knifein
ALeave leads on teTminals "8" and "I" and push in on key (choke position) Light should be on Continue holding in (choke position)Turn key to start position Circuit tracer light should remain on Figure 21
8Insert thru bolts and torque to 95-100 in Ibs(13.1-13.7 kg m)
9Check starter for operation as outlined in this section
IGNITION SWITCH
Removal
1Disconnect battery leads from battery terminals2Remove ignition switch 3Remove lead wiresTest Ignition Switch Continuity and ResistanceTest Equipment2938-1 circuit tracer, volt ohmmeter
Figure 21Test, Step #2
Disconnect all wires from ignition switch for these tests1With switch inOFF" position, attach 2938-1 circuit tracer leads to terminals "M" andM"Circuit tracer should lightFigure 20