Chrysler 20 and 30 HP Outboard Motors Service Manual OB 3435, Page 90Get this manual
2Connect condenser lead wire to terminal block of breaker point3Install flywheel Figure 8Disconnecting Coil Leads
Figure 7Installing Condenser
GeneralThe ignition coils do not require servicing on regular basishowever, the coil should be kept in clean condition and the terminals and connections must be tight to provide good electrical contact
Figure 9Straightening Bottom Lamination
Removal1Remove flywheel as outlined in this section 2Disconnect coil leads as follows :
4Remove stator from stator ring as outlined in this section 5Pry lip of coil wedge spring up from coil laminations and pry coil off laminationsFigure 10