Chrysler 20 and 30 HP Outboard Motors Service Manual OB 3435, Page 77Get this manual
BAttach leads from connectersFigure 18 Figure 19Removing Trigger Stator
Figure 18Connecting Stator Leads
CWrap wiring harness around leads and insert leads into slot in stator ring2Position the stator on the trigger stator, aligning screw holes 3Insert the stator mounting screws and tighten4Install flywheelsee "FlywheelInstallation"
AWARNING
Wear safety glasses when compressed airworking with
1I nstall trigger stator to stator ring with fou (4) screws
Ground lead is attached with mounting screwFigure 20
TRIGGER STATOR
DescriptionThe trigger stator is mounted under the flywheelIt contains two (2) trigger coils, located 180 apartOne trigger coil controls the No1 cylinder and the other controls the No.2 cylinderThe timing magnets (located in the hub of the flywheel) rotate inside the trigger stator adjacent to the trigger coilsFigure 16RemovalTo remove the trigger stator for inspection or replacement, proceed as follows1Remove flywheelseeFlywheelRemoval" 2Remove C-O stator, see "StatorRemoval" 3Remove trigger stator by removing four (4) screws that hold trigger to stator ring Figure 19