Chrysler 20 and 30 HP Outboard Motors Service Manual OB 3435, Page 49Get this manual
NO GROOVES HERE
Figure 24Inspecting Inlet Needle
BCheck for wear (noticeable play in shaft) and take assemblies apart, if needed, by following steps below 8Remove throttle as follows :
Figure 22Removing Float Lever Pin
ARemove eccentric screw, nylon roller and stop nut from throttle leverFigure 25BRemove two (2) screws that fasten throttle shutter to shaftFigure 25
4Inspect float for wear or damage5Remove and inspect inlet needle and seat as follows :
ARemove inlet needle and unscrew inlet needle seatFigure 23
FUEL JET