Chrysler 100, 115 and 140 HP Outboard Motors Service Manual, OB 3439, Page 199Get this manual
Problem
Possible Cause
Test Procedure
2Motor does not run
1Dead battery2Faulty switch 3Faulty wiring harness4Poor connections at battery5Corroded brushes
Replace or recharge batteryReplace switch Check continuity in harnessRepai or replace as necessaryRemove leads from battery terminalClean terminals and replace leadsRemove motor and replace brushes as outlined in this section Remove fill plug from rese rvoir and run the unit up and down 3-5 times using the power trim switch, then replace fill plug Remove air from hydraulic lines and run unit up and down 3-5 times using the power trim switch, then replace fill plug3Engine tilts slowly