Chrysler 100, 115 and 140 HP Outboard Motors Service Manual, OB 3439, Page 183Get this manual
Reassembly and Shimming 1Press bearing cup in gear housingusing cup installer (Special Tool No 11204) and driver handle (Special Tool NoT 8907), and guide plate from bearing guide set (Special Tool NoT 11209)Figure 29
GUIDE PLATE (T 11209)
DRIVER HANDLE ; (T 8907)
CUP INSTALLER (T 11204)
BEARING CUP
Figure 27Installing Propeller Shaft Seal
13Check condition of lower driveshaft bearingIf bearing is not in good conditionreplace by using Special Tool NoT 11205 bearing installer remover and 11209 bearing guide plateDrive old bearing completely thru bore and drive new bearing in until the top of it is flush with top lip of its bore Figure 28
Figure 29Installing Front Bearing Cup