Chrysler 100, 115 and 140 HP Outboard Motors Service Manual, OB 3439, Page 140Get this manual
BInstall piston in ring compressorSpecial Tool NoT 2996 Figure 41 DAMAGE (COMPRESSOR TOO LOOSE)
RING COMPRESSOR
Figure 41Installing Piston
CAUTION
Staking pins must be in ring gaps and rings must be sealed in grooves or damage can resultTap top edges of compressor making it uniform
Figure 42Tightening Ring Compressor
InstallationCrankshaft
There are indentations at one end of compressorPlace these on top of cylinder to prevent compressor from entering cylinder
1Clean all gasket surfaces and crankcase pa rting line surfaces 2Press seal in lower main bea ing wi th arter spring facing out, using seal installerSpec ial oo No 8925 Press seal in until seal case is flush with end of bearingSealing lip and garter spring mu st face out Figure 43
C lnsert piston in cy linder bore