Chrysler 100, 115 and 140 HP Outboard Motors Service Manual, OB 3439, Page 139Get this manual
4Install connecting rod on alignment pinBevel cut must face "up" toward flywheel end of crankshaft, and so that intake baffle of piston is to the rightFigure 38 -DliIVt:
TOWARDS FLYWHEEL) BEVEL CUT
CONNECTING
CAP INTAKE BAFFLE SIDE
Figure 38Installing Connecting Rod(Cap Shown On Figure 39Installing Piston Pin
5Push alignment pin through connecting rodThen install other spacer with small end towards inside of piston6Push alignment pin through other spacer and th rough piston pin bore on other side of piston 7Install shim bar with end marked "310between large end of fi rst spacer installed and connecting rod
9If new piston pin roller bearings were installed coat them fully with motor oilconnecting rod must slide easily between two (2) spacers 10Install piston rings on piston with bevel on inner edge of ring facing upFigure 40 Use ring expander Special Tool NoT 8926