Chrysler 100, 115 and 140 HP Outboard Motors Service Manual, OB 3439, Page 134Get this manual
ROD CAP SCREWS
Figure 23Driving out Dowel Pins
Figure 25Removing Rod Caps
There are sixteen (16) roller bearings for each crank pin
Group rollers with rod caps 12 Lift crankshaft from cylinder Remove remaining roller bearings and cage halves from crankpins
Be sure to group rollers and cages with their rod caps Do not mix rollers or cages of one rod cap with another13Slide lower main bearing with seal off bottom end of crankshaft14Remove snap ring from groove in three (3) main bearings Remove center main bearing races and caged rollersFigure 26