Chrysler 100, 115 and 140 HP Outboard Motors Service Manual, OB 3439, Page 90Get this manual
3Test each lead wire continuity as follows: ASet up test lightSpecial Tool NoT 2938-1Figure 40 BIf test light does not light, for anyone wire, remove cover, repeat steps 2-A through 3-A above4Install distributor shaft as follows :
6Install cap to housing as follows :
AInstall cap assembly on housinglining up hole in cap wall with locating pin in housingSecure cap to distributor with retain ing clips Figure 42
AInstall bronze spacer on distributor shaftBInstall distributor shaft in distributor housing until bronze spacer on shaft bottoms in distributor housing C.lnstaillarge plain washersmall plain washer and spacer on pulley end of distributor shaft Figure 41 5Install shims and retaining ring as follows :