Chrysler 100, 115 and 140 HP Outboard Motors Service Manual, OB 3439, Page 56Get this manual
CConnect small hook end of return spring on drive pin of carburetor and turn choke shaft counterclockwise until slot is in position to install choke shutterDInstall choke shutter through slot in choke shaft and secure with two (2) screws4On 100 H.P, install inlet needle and seat as follows: AInstall gasket on inlet needle seat
133264 (10 .319 .397 mm)
BInstall inlet needle seat with gasket in carburetor and tighten securely C.lnstall inlet needle 5On 115 and 140 H.P install inlet needl e6Install main fuel jet7Install float as fo ll owsPosition float in carburetor Figure 39Measuring Float Height
Groove pin has grooves at one (1) end of pin onlyBInstall groove pin as shown in Figure 38and drive groove pin in until grooves can not be seen FLOAT16"-132" (1.588-794 mm)