Chrysler 100, 115 and 140 HP Outboard Motors Service Manual, OB 3439, Page 49Get this manual
4Close top carburetor choke shutter fullyWhile holding top carburetor choke shutter closed, close bottom carburetor choke shutter and tighten bottom carburetor choke swivel screw to secure link to swivel5Loosen two (2) screws securing choke solenoid just enough so that solenoid can be moved easily Figure 13 9Release choke solenoid plunger and push plunger back in solenoidPull paper out of carburetor air horns; paper must slide out of carburetor easily or with slight dragIf not, readjust solenoid position Step 710Release choke solenoid plunger and check to see that choke sh utters are horizontal If they are not and are tilted upward, bend choke lever tab which contacts carburetor casting until shutter is horizontalthen repeat step 9
OVERHAUL
General
1There are small differences between the 115, 140 H.P(TC) carburetor and 100 H.P(W8) carburetorThey are covered in this section2Repair kits are availableFor the 100 H.P, it includes body channel welch plug and cup plug; main nozzle; two (2) throttle shutter screws with lockwashersidle screw springthrottle shaft return springfloat lever pinchoke shaft return springinlet needleseat and gasketA complete carburetor gasket set is also available For the 115 and 140 H.P, it includes body channel welch plug; main nozzlefour (4) choke and throttle shutter screwsidle screw springthrottle shaft return springchoke shaft return springinlet needleA complete gasket set is also available