2007-2010 Kawasaki Ultra 250X/260X/260LX PWC Factory Service Manual, Page 416Get this manual
ELECTRICAL SYSTEM 14-57 Sensors
Water Temperature Sensor Inspection
Remove the water temperature sensor (see Fuel (OFI) System chapter) Suspend the sensor [A] in container of water so that the temperature-sensing projection is submerged Suspend an accurate thermometer [B] in the water
sensor and thermometer must not touch the con tainer side or bottom
Place the container over source of heat and gradually raise the temperature of the water while stirring the water gently Using the hand tester, measure the internal resistance of the sensor at the temperatures shown in the table If the hand tester does not show the specified valuesreplace the sensorWater Temperature Sensor Resistance Water Temperature 20C (68F) 50C (122F) 90C (194F) 100C (212F) Sensor Resistance approx293 kG approx 78.5 kG approx 18.1 kG approx 13.2 kG
I 006 85 C
Inlet Air Temperature Sensor Inspection
Refer to Inlet Air Temperature Sensor Section in the Fuel System chapter