2007-2010 Kawasaki Ultra 250X/260X/260LX PWC Factory Service Manual, Page 409Get this manual
14-50 ELECTRICAL SYSTEM Kawasaki Smart Steering System
Turning the steering shaft fully in left and right directioncheck whether the steering position sensor comes in contact with the magnet Check the clearance [Aj between the steering position sensor [Bj and the magnet [C] with feeler gaugeSteering Position Sensor Clearance Standard: 0.51.5 mm (0.020.06 in
If necessary, adjust the steering shaft nut Check the operation of Kawasaki Smart Steering system
Inspection of Kawasaki Smart Steering System
Inspect the smart steering system with the watercraft in the water Center the handlebar in the straight-ahead position Squeeze the throttle lever and allow it to approx4 000 rpm or above for seconds or more Release the throttle lever Within secondturn the handlebar all the way to the left or right and check the engine speed increases to approx3300 rpmand then decreases to approx2600 rpm Center the handlebar in the straight-ahead positionand check the engine speed decreases to an idle speed If the Kawasaki Smart Steering system does not operate normally, check the steering position sensor clearance