2007-2010 Kawasaki Ultra 250X/260X/260LX PWC Factory Service Manual, Page 404Get this manual
ELECTRICAL SYSTEM 14-45 Ignition System
Crankshaft Sensor Peak Voltage Check
a Be sure the battery is fully charged Connect the peak voltage adapter [A] to the hand tester [B]Special ToolPeak Voltage Adapter: 57001-1415 Type: KEK-54-9-B
Connect the adapter the crankshaft sensor lead connector [C]using the needle adapter set [0] Special ToolsHand Tester: 57001-1394 Needle Adapter Set: 57001-1457 Connections Adapter Adapter (BK-)
Crankshaft Sensor: G
Hand Tester Range: DC 10 V
Turn the ignition switch on and push the lanyard key under the stop button Pushing the starter buttoncrank the engineseconds to measure the crankshaft sensor peak voltage 00 not operate the starter for longer than secondsWait 15 seconds before using it again Repeat the measurements or more times Crankshaft Sensor Peak Voltage Standard: 2.5 or more
If the reading is less than the specified value, check the
crankshaft sensor (see Crankshaft Sensor Inspection)