2007-2010 Kawasaki Ultra 250X/260X/260LX PWC Factory Service Manual, Page 402Get this manual
ELECTRICAL SYSTEM 14-43 Ignition System
Camshaft Position Sensor Inspection
Remove: Seat (see Seat Removal in the HullEngine Hood chapter) Camshaft Position Sensor Lead Connector [A] (disconnect) Set the hand tester [B] to the 10 range and connect it to the yellow and black leads in the connector
Special Tool- Hand Tester: 57001-1394
If there is more resistance than the specified valuethe sensor coil has an open lead and must be replaced Much less than this resistance means the sensor coil is shortedand must be replaced Camshaft Position Sensor Resistance: 400460
Using the highest resistance range of the tester, measure the resistance between the camshaft position sensor leads and chassis ground Any tester reading less than infinity (00) indicates short, necessitating replacement of the camshaft position sensor
Igniter RemovalInstallation