2007-2010 Kawasaki Ultra 250X/260X/260LX PWC Factory Service Manual, Page 299Get this manual
DRIVE SYSTEM 10-7 Drive ShaftDrive Shaft Holder
OPress the small grease sealand the large grease sealsbearingand small grease seals come out of the holder[Aj Sleeve [Bj Blocks [C] Press
Drive Shaft Holder AssemblyInstallation
Replace the grease seals with new ones Press the bearing and grease seals into the drive shaft holder, noting the following Olnstall the parts in this orderTwo Small Grease Seals [Aj One Bearing [Bj Two Large Grease Seals [C] Front [Dj
Special ToolBearing Driver Set: 57001-1129
Olnstall the seals so that the sides with the spring face outwardOFili the gaps between the seals with water resistance grease [Ej Install the circlip Apply water resistance grease to the bearing inner surface and grease seal lips