2007-2010 Kawasaki Ultra 250X/260X/260LX PWC Factory Service Manual, Page 291Get this manual
9-18 COOLING AND BILGE SYSTEMS After Submerging
8Pull and remove all the spark plug caps9Remove all spark plugs10Insert the ignition switch key, push the lanyard key under the stop buttonand push the start button 11 If there is water in the engineit will be pumped out from the plug holes, discharge the waterDo not operate the starter for longer than seconds Wait 15 seconds before using it again
A WARNING
Do not lean over the engine when performing this procedureA water and gasoline mixture will be forcibly ejected from the spark plug holes and could get into your eyesIf you do get some in your eyes, wash your eyes immediately with liberal amounts of clean, fresh waterConsult physician as soon as possible12If there is no water coming out of the enginespray the spark plugs clean with air and then restore them with their plug caps13Reconnect the primary ignition lead connectors 14Reconnect the primary ignition coil lead connectorsnoting the #1 ,#4 [A] and the #2#3 [B] coil connectors The #1, #4 coil connector has redyellow and greenblue leads from the main harness The #2, #3 coil connector has redyellow and greenblack leads from the main harness