2007-2010 Kawasaki Ultra 250X/260X/260LX PWC Factory Service Manual, Page 280Get this manual
COOLING AND BILGE SYSTEMS 9-7 Cooling and Bilge System Hoses
Hose Removal
The majority of bilge hoses have no clamps at the hose endsThe majority of bilge system hoses may be simply pulled off their fittings
O$ome of the bilge system hoses have plastic clamps at hose ends All the cooling system hoses are clamped at both endsLoosen the clamps and pull the hoses off
Hose Installation
To install the bilge filter hose, push the hose over the end of the filter
O$ome of the bilge system hoses have plastic clamps at hose ends When installing the cooling system hoses, be sure to use the same kind of clamp as the originalSome of the clamps are metal for tighter clamping ability (required when smooth fittings are used)Plastic clamps are used where tight clamping is not required