2007-2010 Kawasaki Ultra 250X/260X/260LX PWC Factory Service Manual, Page 257Get this manual
8-10 ENGINE BOTTOM END Coupling
Replace the oil seals with new ones Apply thin coat grease to the oil seal lips [A] Pack grease [B] between the oil seal lip and housing of the oil seal (flywheel side oil seal [C]) Press in the oil seals until they are bottomed Olnstall the coupling oil seal [0] so that the manufacturer's marks [E] face coupling sideO lnstall the flywheel side oil seal so that the dust seal [F] side face out
Oil Seal Inspection
Inspect the oil sealO Replace it if the lips are misshapendiscolored (indicating that the rubber has deteriorated)hardened or otherwise damaged
Magneto Cover Bearing Replacement CAUTION
Do not remove the ball bearing unless it is necessaryRemoval may damage it Remove: Magneto Cover (see CouplingOutput Shaft Removal) Using the oil seal and bearing remover [A]remove the ball bearing from the magneto cover [B] OWhen removing the ball bearinghold the magneto coverSpecial Tool- Oil Seal and Bearing Remover: 57001-1058