2007-2010 Kawasaki Ultra 250X/260X/260LX PWC Factory Service Manual, Page 255Get this manual
8-8 ENGINE BOTTOM END Coupling
Using the rotor holder [A], remove the output shaft [B]Special Tool- Rotor Holder: 57001-1544
CouplingOutput Shaft Installation
Apply molybdenum disulfide oil solution to the seating surface of the output shaft Using the rotor holder [A]install the output shaft [B] Special Tool- Rotor Holder: 57001-1544 TorqueOutput Shaft: 245 Nm (25.0 kgfm, 180 ftlb) (JT1500B7FB8FE9F Early ModelF9F Early Model) Output Shaft: 265 Nm (27.0 kgfm, 195 ftlb) (JT1500E9F Late Model -F9F Late Model)
Apply silicone sealant [A] to the crankcase halves mating surfaces on the magneto cover Be sure to install the dowel pins [B]