2007-2010 Kawasaki Ultra 250X/260X/260LX PWC Factory Service Manual, Page 185Get this manual
ENGINE LUBRICATION SYSTEM 4-21 Oil Pump Sprocket, Oil Pump and Oil Pressure Relief Valve
Oil Pump Installation
Apply molybdenum disulfide oil solution to the outer and the inner rotors out side Install the outer rotor [A] into the oil pump body Apply molybdenum disulfide oil solution to the shaft Assemble the pin [B]inner rotor [C] onto the oil pump shaft [D]OFit the pin into the slot of the inner rotor Insert the shaft assembly Be sure the dowel pin [E] is in place in the pump body Fit the new a-ring [F] to the groove of the pump body Fit the oil pump cover and tighten the cover bolts TorqueOil Pump Cover Bolts: 7.8 Nm (0.80 kgf.m69
Install: Oil Pump Sprocket (see Oil Pump Sprocket Installation) Oil Pan (see Oil Pan Installation)
Oil Pump Inspection
Remove the oil pump parts Visually inspect the oil pump outer, inner rotors and coverIf there is any damage or uneven wear, replace the rotors and cover