2007-2010 Kawasaki Ultra 250X/260X/260LX PWC Factory Service Manual, Page 177Get this manual
ENGINE LUBRICATION SYSTEM 4-13 Oil Cooler
Oil Cooler Removal
Remove: Seat (see Seat Removal in the HullEngine Hood chapter) Inlet Manifold (see Inlet Manifold Removal in the Fuel System (DFI) chapter) Disconnect the oil pressure switch connector [A] Loosen the clamp screws [B] and remove the oil cooler cooling hoses [C] from the oil cooler Remove the oil filter [A] with the oil filter wrench [B] OPlace rag or cloth [C] under the oil filter to receive the remaining oilSpecial ToolOil Filter Wrench: 57001-1249
Unscrew the oil cooler positioning bolt [A] Unscrew the oil passage bolt [B] and remove the oil cooler [C] Place rag or cloth [0] under the oil cooler to receive the remaining oil