2007-2010 Kawasaki Ultra 250X/260X/260LX PWC Factory Service Manual, Page 157Get this manual
3-98 FUEL SYSTEM (OFI) Fuel Pump
Fuel Pump Installation
Press down the rubber holder [A] onto the fuel pump [B) so the stepped part [C] of the holder completely contacts the flanged part [0] of the pump Pressing down the rubber holder onto the fuel pumptighten the small diameter clamp [E)
o Install the rubber holder onto the fuel pump so the rubber holder top surface [FJ must be below the top surface [GJ of the fuel pump to prevent any water from collecting on top of the pump
JC080 lBS2
Install the a-ring [A] to the space between fuel pump [B) and rubber holder [C] so it completely contacts the flanged part [0] of the pump (JT1500B7F model) Insert the fuel pump with rubber holder and a-ring into the tank so its fuel hose fittings face starboard side (see CableWireand Hose Routing in Appendix chapter) And press down the pump so the a-ring [A] completely contacts the top surface of the tank [E) (JT1500B7F model) Insert the fuel pump with rubber holder into the tank so its fuel hose fittings face starboard side (see CableWire and Hose Routing section in Appendix chapter) And press down the pump so that the fuel pump completely contacts the top surface of the tank [E) (JT1500B8FE9FIF9F models) Tighten the large diameter clamp [F) securelyJT1500B7F Model [G) JT1500B8FE9FIF9FModels [H)