2007-2010 Kawasaki Ultra 250X/260X/260LX PWC Factory Service Manual, Page 149Get this manual
3-90 FUEL SYSTEM (DFI) Inlet Manifold
Place the delivery pipe with the harness [A] out of the engine compartment as shown
Unscrew the inlet manifold mounting bolts [A] and nuts [8]
Remove the inlet manifold [A] with two bolts [8] indicated in the figure
Inlet Manifold Installation
Replace the inlet manifold gasket with new one Tighten :
TorqueInlet Manifold Drain Plug: 20 Nm (2.0 kgf.m14 ft.lb) Inlet Air Temperature Sensor: 20 Nm (2.0 kgfm14 ft.lb)