2007-2010 Kawasaki Ultra 250X/260X/260LX PWC Factory Service Manual, Page 130Get this manual
FUEL SYSTEM (OFI) 3-71 Throttle lever, Cable and Case
Disassemble the throttle caseORemove the circlip [A], flat washers [B], pin [C] throttle lever [0] and return spring [E] from the case [F]
Throttle Case AssemblyInstallation
Insert the end of the return spring [A] in the throttle lever hole [B] and set the spring in the throttle case [C] as shown Install the control lever to the case
Lubricate the throttle cable before assemblyinstallation Apply water resistant grease to the tips of the throttle ca ble end Pull ing the throttle cable [AJ, position the tips [B] of the cable end as shown Tighten the cable fitting nut