2007-2010 Kawasaki Ultra 250X/260X/260LX PWC Factory Service Manual, Page 94Get this manual
FUEL SYSTEM (OFI) 3-35 Inlet Air Temperature Sensor (Service CodeCharacter-13Alrt)
Inlet Air Temperature RemovalInstallation CAUTION
Never drop the sensor, especially on hard surfaceSuch shock to the sensor can damage it Disconnect the following to make service easySpark Plug Caps Fuel Hose Air Bypass Hose (Upper Side) Disconnect the connector [AJ from the inlet air temperatu re sensor Remove the inlet air temperature sensor [BJ and washer Install the inlet air temperature sensor and washer [AJ Tighten :
TorqueInlet Air Temperature Sensor: 20 Nm (2.0 kgf.m, 14 ft.lb)
JC160020 P
Output Voltage Inspection NOTE
a Be sure the battery is fully charged Remove the ECU (see ECU Removal)Do not disconnect the ECU connector Connect digital voltmeter to the ECU connector, using needle adapter setSpecial ToolNeedle Adapter Set: 57001-1457 Inlet Air Temperature Sensor Output Voltage Connections to ECU Connector Meter (+) Meter (-)