2003 Kawasaki JetSki 800 SX-R Factory service manual, Page 222Get this manual
STORAGE 14-3 Preparation for Storage
Turn the ignition switch onPush the lanyard key under the stop button, and start the engine and run it in 15 second periods until all fuel in the carburetor is used upWait minutes between 15 second running periodsPull the lanyard key off the stop button and turn the ignition switch off
CAUTION
Do not run the engine without cooling water supply for more than 15 seconds, especially in high revolutionary speed, or severe engine and exhaust system damage will occur
Lift out the flame arresters [A] and clean them, if necessary (see Flame Arrester Cleaning in the Periodic Maintenance chapter)Spray penetrating rust inhibitor down the carburetor boreInstall the flame arrestersReinstall the cover, apply non-permanent locking agent to the threads of the air inlet cover boltsTorque Air Inlet Cover Mounting Bolts: 8.8 N-m(0.9 kgf-m, 78 in-lb)