2003 Kawasaki JetSki 800 SX-R Factory service manual, Page 152Get this manual
11-6 HANDLE POLE AND HANDLEBAR Steering Cable Remove the pump cover (see Pump Removal in the Pumpllmpeller chapter)a Disconnect the steering cable from the fitting at the rear of the hull0 Unscrew the steering cable nut [A] while holding the fitting in the hull with wrencho Slide off the snap ring [B], washer [C], and O-ring [DlBow [El
Remove: Exhaust Manifold (see Engine Top End chapter) Pull the cable from cable detent [A] in the engine compartmentRemove the cable by carefully pulling [B] rear section of the cable through the hull [C]
Lay the handle pole little rearwards, and remove the cable by carefully pulling the front section of the cable [A] through the handle pole