2003 Kawasaki JetSki 800 SX-R Factory service manual, Page 142Get this manual
PUMP AND IMPELLER 10-7 Pump and Impeller
When installing the pump case [A], be careful that the trim seal [B] is stayed in placeBow [C] If necessary, apply water or oil to the surface of the trim seal
need to apply silicone sealant between the pump (trim seal) and the hull
When installing the drive shaft [A], fit the drive shaft into the spline of the impeller such that no clearances [B] exist between the shaft end and the O-ring [C]Bow [Dl Apply non-permanent locking agent to the pump mounting bolts and torque themTorque Pump Mounting Bolts: 22 N-m (2.2 kgf-m, 16 ft-lb)