2003 Kawasaki 1100 STX D.I. Jet Ski Factory Service Manual, Page 270Get this manual
STORAGE 15-3 Preparation for Storage
the air [A] from Removethe flameintake coverand clean the throttle body(see Flame Lift out arresters Arrester Cleaning in the Fuel System them, if necessary chapter) Spray penetrating rust inhibitor down the throttle body boreflame arrester Install the the cover, apply non-permanent locking agent to the Reinstall threads of the air intake cover bolts and tighten securely
plugs Remove theonsparkelectricand push the plug caps fully onto the plug cap holder the case Pour one ounce of motor oil into each cylinder
CAUTION
Do not use too much oil, or the crank seals may be damaged when the engine is next startedon Turn the ignition switchunder the stop buttonTurn the engine over Push the lanyard key several times with the start button to coat the cylinder walls with oil Pull the lanyard key off the stop button and turn the ignition switch off Reinstall the spark plugs and caps