2003 Kawasaki 1100 STX D.I. Jet Ski Factory Service Manual, Page 248Get this manual
ELECTRICAL SYSTEM 14-27 Ignition System
Crank Position Sensor (CPS) Peak Voltage Check:
Be sure the battery is fully charged
Disconnect the CPS lead connectorPull all the spark plug caps from the spark plugs and push the caps [A] fully onto the spark plug cap holder [B]
Maintain the correct value of compression pressure for the cylinder (Be sure to measure the voltage with the spark plug installed to the cylinder head)
Connect commercially available peak voltage adapter [B] to the hand tester [A]Recommended Tool: Peak Voltage Adapter Type: KEK-54-9-B Brand: KOWA SEIKI
the adapter probes into Insertfor the CPS as shownthe connector [C] of the magneto cover side
Special Tool Connections: CPS Coil: Adapter (R, +) (Orange) DC 10 Adapter (BK,BK Hand Tester: 57001-1394
Hand Tester Range:
Turn the ignition switch on and push the lanyard key under the stop buttonstarter button, crank Pushing the CPS peak voltagethe engine seconds to measure the