2003-2005 Kawasaki JetSki Ultra-150 Factory Service Manual, Page 240Get this manual
ELECTRICAL SYSTEM 14-39 Electric Trim System
Trim Actuator Inspection
Inspect the internal resistance of the trim angle sensor [A]the WR terminal and the BLR terminalTrim Angle Sensor Resistance: 479 718
Disconnect the trim actuator connector [B]Using the hand tester, measure the resistance between
Disconnect the trim actuator connectors [A] [B]Using the auxiliary wires, connect the trim actuator termiConnect the hand tester to the trim actuator terminal as
shownMove the nozzle by pushing the trim switchCheck that the meter readings are variableIf the meter readings are not variable, the trim angle sensor defectivenals to the main harness terminals as shown
the limit switch function the trim angle Inspect nozzle full up position byofpushing the trimsensorswitchSet the
Disconnect the trim actuator connectors [A]Using the hand tester, check to see the following connectionWhen the nozzle is full up position RBK-W: around [B] RBK-BKW [C]