2003-2005 Kawasaki JetSki Ultra-150 Factory Service Manual, Page 130Get this manual
ENGINE BOTTOM END 8-9 Magneto Flywheel
Install the magneto flywheel [A] on the balancer drive gear [B]
Align the maker mark [C] on the magneto flywheel with
the key groove [D] on the gear [B]Apply non-permanent locking agent to the balancer drive gear mounting bolts [E] and tighten them, following the sequence shownTorqueBalancer Drive Gear Mounting Bolts: 12 Nm (1.2 kgfm, 8.7 ftlb)
Stater Clutch Gear and Starter Idle Gear Removal
Remove: Cover Magneto