2003-2005 Kawasaki JetSki Ultra-150 Factory Service Manual, Page 38Get this manual
PERIODIC MAINTENANCE 2-9 Periodic Maintenance Procedure
adjust [A] If necessary,turn thethe carburetor cablecable holder until locknuts [B] at the Loosen and
the lower stop on the pivot arm hits against the idle adjust screw with slight cable slackTighten the locknuts securelyCheck the oil pump cable adjustment (see Fuel System chapter)If necessary, adjust the oil pump cable
Oil Pump Cable Adjustment
adjustment Check carburetor cable carburetor cable If necessary, adjust theadjustmentoil Check the pump cable is fully applied (pulled), check to When throttle lever see that there is clearance [A] (approx0.6 mm (0.024 in) between stop [B] on the oil pump pulley and the stopper pin [C] on the oil pump bodyAt this time, the oil pump pulley is fully opened
If necessary, adjust the oil pump cable [A]Hold the throttle lever fully applied (pulled)Turn the oil pump pulley till the stop on the pulley contacts to the stopper pin on the oil pump bodyAt this time, the oil pump pulley is fully openAnd then give the oil pump cable tension by turning the upper adjusting nut clockwiseLoosen the upper adjusting nut [B] by turning counterclockwise 12 turn and then fix the oil pump cable by tightening the lower adjusting nut [C] securely