2000-2001 Kawasaki 1100 STX D.I. Jet Ski Factory Service Manual., Page 171Get this manual
9-6 DRIVE SYSTEM Drive ShafWrive Shaft Holder
0 Press the small grease seal, and the large grease seals, bearing, and
small grease seals come out of the holder[A] Sleeve [B]Blocks [C]Press
Drive Shaft Holder AssemblyInstalation Replace the grease seals with new ones Press the bearing and grease seals into the drive shaft holder, noting
the following
2 Install the parts in this orderTwo Small Grease Seals [A] One Bearing [B] Two Large Grease Seals [C]
Front [Dl
Special Tool
Bearing Driver Set: 57001-1129
2 Install the seals so that the sidles with the spring face outward Fill the gaps between the seals with grease [El
Install the circlip Grease to the bearmg inner surface and grease seal lips
a Install the drive shaft holder on the bulkhead so that the circlip side
face toward the front