2000-2001 Kawasaki 1100 STX D.I. Jet Ski Factory Service Manual., Page 155Get this manual
7-12 ENGINE BOTTOM END Crankcase 0 Place the crankshaf assembly [A] in the upper crankcase half0 The position ring [B] and the projected outer circumference [C]
the oil seals on the crankshaft assembly fit into the grooves in the crankcase2 The pins [Dl on the bearings and labyrinth packings on the crankshaft assembly fit into the grooves in the crankcase
Check that the knock pins [A] are in place With high flash-point solvent, clean off the mating surfaces of the
crankcase halves and wipe dry Apply liquid gasket to the mating surface of the lower crankcase half0 Install the lower crankcase half onto the upper half
0 Apply nonpermanent locking agent to the crankcase bolts, and
tighten themTorque