2000-2001 Kawasaki 1100 STX D.I. Jet Ski Factory Service Manual., Page 33Get this manual
GENERAL INFORMATION 1-27 Technical InformationTheorv of Direct Fuel Iniiection
The sensor receives voltage signal from the EMM, and another wire provides ground circuit back to the EMMThe EMM uses this signal to adjust the aidfuel ratio in accordance with changes in incoming air temperaturesIf sensor values are above expected range, the EMM will initiate S.L.O.W store service code, and turn on the "CHECK ENG lightAT sensor value below the expected range will store service code and turn on the "CHECK ENG light, but will not put the engine into S.L.O.W(2) Water Temperature (WT) Sensor The water temperature sensor is located on the exhaust pipe, and it does not actuallv contact the waterThe WT sensor monitors enaine