1995-2004 Kawasaki JetSki 750ZXi 900ZXi Factory Service Manual, Page 10Get this manual
'1-4 ,GENERAL INF'ORMATION
(15) Seal Guide Aseal ,guide is required for certain ill! or g,re:ase seals duringinstailation to avoid da,mage to the seal lipsBefore 8, shaft passes, throug,h seal, app,ly II,itt,le, lubricant, preferablyhig,h temperature grease on the lips to reduce' 'rubber to metal friction(16) CirclipRetain.ing Ring! Replace any circlips and retaining rings thst were removed with ,new ones, ,as removal weakens and deforms themWhen instaIUngcirclip,s, and retaininq rinqs, take care to compress or expand them only enouqh to install them and no more, (17) Cotter Pin Beplaceanv cotter pins that were removed with new ones, as removal deforms and breaks them(18) Lubrication Engline wear ,is generaUy at its maximum while the engine is war,ming up and before aU the rubbing surfaces have an adequate lubric,8tiv,ef'iI'!mDu!ring assembly, oil or g',rea:se (whichever ismora suitable) should beapplied to any rubbing surface which has lost its, tubricative fitm.O'd glrease, and dilrty alii should be cleaned offDetenorated grease has lost its tubricative quali:ty andmav contain abrasive for,e'ign particles, Don't use just any oi,l or greaseS,om,e oils and greases in particular should be used only in certain applications: and mav be harmful if used in a:n epplication for which they are not intended(19) Eli,ectr,icaIW.res AU the electrical wires areeither single-colo!r or two-coior and, with onily fsw exceptions, must be connected towires of the same colorOn any of the two-coilor 'wires ther,a is greater amount of one color and lesser amount of second cotor, so tw'o-cof,or wire is identified byfiirst the p!rim:ary color and then the seconda.rycolorFor' e'xamp,I,e, v,e,uow wilrewith th,in red stripes is ref,erlred to as "yellowlred wi,re'; it would be ,a "'redyeUow" wire Ii' the colors were reversed to make red the main color'Wire (cross-section)