1995-1997 Kawasaki 750ZXi-900ZXi Jet Ski Repair Manual., Page 121Get this manual
DRIVE SYSTEM 9-5
0Press the small grease seal, and the large grease seals, bearing, and small grease seals come out of the holder[A] Sleeve [B] Blocks
Drive Shaft Holder Assem&!ynstallation
8 Replace the grease seals with new onesPress the bearing and grease seals into the drive shaft holder, noting the following0Install the parts in this order Two Small Grease Seals [A] One Bearing [Ql Two Large Grease Seals [C]
Special ToolBearing Driver Set: 57001-1129
0 Install the seals so that the sides with the spring face outward0 Fill the gaps between the seals with grease [Dl
Instalthe circlipGreas to the bearing inner surface and grease seal lips
Instal the drive shaft holder on the bulkhead so that the circlip side face toward the front(Apply nn-permanentlocking agent to the drive shaft holder mounting bolts, tighten them looselyInstalthe drive shaft (After installing the engine, tighten the drive shaft holder mounting bolts to the specified torque to give proper coupling alignmentTorque