1995-1997 Kawasaki 750ZXi-900ZXi Jet Ski Repair Manual., Page 106Get this manual
ENGINE BOTTOM END 7-17
Connecting Rod Big End Radial Clearance
Chec big end radial clearanceOSet the crankshaft in an alignment jig or on bllocks, and place dial gauge against the connecting rod big endOPush the connecting rod first towards the gauge and then in the opposite direction The difference between the gauge readings in the radial clearancethe &f radial cllearance exceeds the service limit, the crankshaft assembly must be replaced or disassembled and the crankpin, needle bearing, and connecting big end examined for wearrod Connecting Rod Big End Radial Clearance JH9MA 0.018 0.030 mm Standard: JH750C 0.018 0.029 mm Service Limit: JH900A 0.080 mm JH750C 0.079 mm
Connecting Rod Big End Clearance
Measur big end side clearance [A]0Insert feeler gaugesbetween the big end and either crank half to determine clearanceIf the measured value exceeds the service limit, the crankshaft should be either replaced or rebuiltConnectlng Rod Big End Side Clearance Standard: 0.45 0.55 mm Service Limit: 0.8 mm