1992-1998 Kawasaki PWC Jet Ski Service Repair Manual., Page 275Get this manual
INSTALLATION Tighten the hose clamp SECURELYIf the hose should blow off, the supply cooling to the ehgine would cease Instantly and the engine would overheat6- Pull back the steering cable end and snap the end the steering ball joint on the steering of the nozzle7- the bilge hose to the on the hullS the hose with hose clamp8- Apply coating of Loctitc Stud N' Bearing Mount Compound Coat to the threads of the (four) pump attaching bolts9- Install the cover over the jet pumpSecure the cover with the attaching bo tighten them alternately and evenly to torque value of 16 ft Ib (22Nm)550 Series; 87 in lb (9.8Nm) 650 Series; 69 in lb (7.8Nm) 750, 900 and 1100 Series10- Apply coating of Loctite Stud N' Bearing Mount Compound the of the rock grate boltsInstall the rock grate and tighten the bolts to torque value of 87 in lb (9.8Nm)Rotate the craft uprightInstall the battery and connect the cables to the proper terminalsInstall or fill the fuel tankFill the oil injection tank (on all Models other than the 550 Series)The oil injection system MUST be bled while operating the engine on premix as directed in Section 6-9 of Chapter FUEL 10-29