1992-1998 Kawasaki PWC Jet Ski Service Repair Manual., Page 242Get this manual
ELECTRICAL
Before installing the two rear mounting bolts, measure the distance between the rear mounting bracket and the crankcase, Fill this space with the original pieces of shim material or purchased piecesShim material is available in thicknesses of O.4,O.G and 0.8mmInstall the two rear mounting bolts and tighten them to torque value of 52 in Ib (6Nm)2- Connect the battery ground ca battery
NEVER, AGAIN, NEVER operate the engine at high speed with flush device attachedThe engine, operating at high speed with such device attached, would RUNAWAY from lack of load on the impeller, causing extensive damage9-7 TESTING OTHER
ELECTRICAL COMPONE
This short section provides testing procedures for other electrical parts installed on the engineIf unit fails the testing, the faulty part ST be replacedIn most cases, removal and installation is through attaching hardware
ALL SERIES Check Completed Work Secure the craft in test tank or body of waterIf body of water or lank is not possible, connect flush attachment and hose to the jet