1992-1998 Kawasaki PWC Jet Ski Service Repair Manual., Page 168Get this manual
ASSEMBLE 2-CYLINDER
harness connector through the opening in the plate and position the magneto assembly the end of the crankshaftPush the into the opening and secure it in place with the screwsTighten both screws securely
Timing Marks
Identify the two marks on the magneto assembly and the plate prior removalThese marks serve to position the the plateT securing screws pass through elongated slots in the magneto assemblyTherefore, the assembly could be installed as much as 15 to its original position, drastically affecting the timing tics of the en ineIf NEW assembly is bei installed, match the new assembly to the old assembly and new mark as the original location as possibleThe be timed accord outlined in Section 7s ing the pro 7, of 7If NO timing marks were made prior to removal of the magneto assembly, as ins ted in Disassembling, closely inspect the elongated slots in the assembly and to the original positioning of the screwsIf no identifiable mark be found, center the magneto assembly in the slotThis position may not be close to the position to the engine startDetailed timing procedure is presented in Section 7-7, of 7