1992-1998 Kawasaki PWC Jet Ski Service Repair Manual., Page 131Get this manual
IGNITION
Model 550 Identification of connector pin openings mentioned in the text for making charging coil output teat
Model 650 Identiftmtion of the Yellow charging coil connectors to be aaporated in preparation to making charging coil output test, described in the text
Move the meter to the 25 VAC setting, and then make contact with the Black meter lead to the Black pin opening in the connector, as indicated in the accompanying illustrationMake contact with the Red meter lead to one of the Light Green pin openings in the connectorRecord the meter readingWith the engine still operating, make contact with the Black meter lead again to the Black connector pin openingMake contact with the Red meter lead to the other Light Green pin openingRecord meter readingShut down the engineIf the voltage is satisfactory 1215 VAC check the regulatorIf the charging coil output voltage is low, check the charging coil resistance with ohmmeter as follows: Set the meter to the scaleMake contact the Black meter lead to the Black connector pin openingake contact with the Red meter lead to one of the Light Green pin openingsMeter should indicate resistance of 1.2 1.8 ohms, Make contact with the Black meter lead again to the Black pin opening and the Red meter lead to the other Light Green pin openingThe meter should again indicate 1.21.8 ohmsNow, make contact with the Black meter lead to one of the Light Green pin openin Red meter lead to the other Light Green pin openingThe meter should indicate 2.43.6 ohms