1991+ Kawasaki 650 SC Factory Service Manual, Page 110Get this manual
10-8 PUMP AND IMPELLER
Pump Assembly
Before installing the pump bearings, blow any dirt or foreign particles out of the pump case with compressed sir Install new bearings
Special ToolBearing .Driver Set: 57001-11.29 [AJ
o Press the rear pump bearing into the pump case as tar as it will goo Insert the coliar and instaH the front pump bearing
Replace the grease seals with new ones, if necessary, and install them using the same special tool used for be.aring instllationo Press each seal into the pump case so that the side with the spr.ing faces outwardFill the gap between the seal with grease Push the bushing into the pump case Visually inspect the pump shaft O-rings, and replace them it necessary Grease the pump shaft and insert it from rear of the pump case Screw on the impeller