1991+ Kawasaki 650 SC Factory Service Manual, Page 107Get this manual
PUMP AND IMPELLER 10-5
Pump' Installation
.Strip off all the old sealant around the pump intakee,Grease the splines on the drive shaft with water res,istal'lt grease, and be sure th O-ring is in place inside the pump shafteWhenever the pump or hulil is replaced Wiith new one, checkthe clearance between the pump ltabs and the hull before tightening the pump boltso If there ar,e gaps between them, insert shims as required to jlust take up the clearance
Shim Selection Shim No
92025-3701 92025-3702 92025-3703 92025-3704
Thickness to.3 mm
to.S mm t1.0 mm t1.S mm
eCoat on area 10 to 20 mm wlide [Aljust behind the edge line [8] wlith plenty of silicone sealant [C]SealantKawasak.ll, Bond (Silicone Sealant): 56019-120