2008 Yamaha Raptor 250SE / 250SE2 Factory Service Manual, Page 98Get this manual
ADJUSTING THE TOE-INCHECKING THE FRONT AND REAR SHOCK ABSORBERS
aMark both tie-rods endsThis reference point will be needed during adjustmentbLoosen the locknuts (tie-rod end) of both tie-rodscThe same number of turns should be given to both the right and left tie-rods until the specified toe-in is obtainedThis is to keep the length of the rods the samedTighten the rod end locknuts of both tie15 Nm (1.5 mkg, 11 ftlb) rodsNOTE: Adjust the rod ends so that and are equal