2007-2008 Yamaha YFM700 Grizzly Factory Service Manual, Page 75Get this manual
CABLE ROUTING Fasten the final gear case breather hose, ground lead, starter motor lead, fuel injector lead, coolant temperature sensor lead, AC magneto lead, and wire harness with the plastic band, making sure to position the band near the split in the wire harness Route the fuel injector lead and coolant temperature sensor lead to the inside of the ground lead, starter motor lead, final drive gear case breather hose, and wire harness
Face the end of the plastic band inward Pass the plastic band through the hole in the plastic cover, and then fasten the leads and hose with the band, making sure to face the end of the band downward Insert the projection on the coupler into the hole in the frame from the inside of the frame Face the end of the plastic band inward Fasten the spark plug lead with the larger diameter section of each holder