2006-2009 Yamaha YFM700RV Raptor 700RV factory service manual, Page 252Get this manual
FUEL INJECTION SYSTEM
Setting the diagnostic mode 1Turn the main switch to "OFF" and set the engine stop switch to "RUN"2Disconnect the wire harness coupler from the fuel pump3Remove the self-diagnosis signal coupler cap, and then connect the FI diagnostic tool as shown4While press the "MODE" button, turn the main switch to "ON"NOTE: "DIAG" appears on the LCD of the FI diagnostic tool "POWER" LED (Green) comes on_
5Press the "UP" button to select the CO adjustment mode "CO" or the diagnostic mode "DIAG"6After selecting "DIAG", press the "MODE" button7Select the diagnostic code number corresponding to the fault code number by pressing the "UP" and "DOWN" buttonsFI Diagnostic Tool